Skip Navigation
  1. BlackBerry Docs
  2. BlackBerry AtHoc
  3. BlackBerry AtHoc Integrations
  4. Cisco IP Phone Blast NDS Installation Guide
  5. Install and configure the IP Phone Blast on AtHoc NDS
  6. Install the IP Phone Blast on NDS

Install the IP Phone Blast on 
NDS

Before you begin, verify that you are running on 
NDS
. Installation will be unsuccessful if 
AtHoc
 
NDS
 is not located at: <Drive>:\Program Files (x86)\AtHocENS\Installation.
The Blast System utility is a wizard that installs all three 
BlackBerry AtHoc
 modules.
  1. Go to the working folder where you placed the 
    CiscoBlastSystemSetup.exe 
     file.
  2. Right-click the 
    CiscoBlastSystemSetup.exe
     file and select 
    Run as administrator
    .
  3. On the 
    User Account Control
     pop-up screen, click 
    Yes
    . The Blast System Installer opens.
  4. On the 
    Welcome
     screen, click 
    Next
    . The Blast system software requirements appear on the screen
  5. Click 
    Next
    .
  6. Verify the following information before continuing with the installation:
    Screen
    Action
    Information
    • If the server meets all the listed requirements, click 
      Next
      .
    • If the server is running 
      AtHoc
       
      NDS
       2.9.7 but does not have 
      Microsoft .NET
       4.7.2 and VS++2010SP1x86 and has an internet connection, click 
      Next
      .
    • If the server is running 
      AtHoc
       
      NDS
       2.9.7 but does not have 
      Microsoft .NET
       4.7.2 and VS++2010SP1x86 and does not have an internet connection, click 
      Cancel
      . You must manually install 
      Microsoft .NET
       4.7.2 and VS++2010SP1x86, and then run the Blast System utility again.
    The utility checks for the specific versions. If they are not found, the installation does continue and displays an error message. Install the appropriate program versions and then run the Blast System utility again.
  7. Select 
    I have read and accept the license terms
    .
  8. Click 
    Install
    . The installation process begins.
  9. In the 
    Select Destination Location
     screen, enter a selected destination location using the following format: 
    <DRIVE:>:\Program Files (x86)\Syn-Apps\CiscoBlastSystemSetup
    The 
    AtHoc
     
    NDS
     must be located at: <Drive>:\Program Files (x86)\AtHocENS\Installation.
    First installation only: Blast System updates target the existing installation folder designated here.
  10. Click 
    Next
    .
  11. In the 
    Environment Requirements
     screen, select the check box beside each item. Installation does not continue until all check boxes are selected.
    You are required to select the check boxes only once. The system considers the state of the check boxes from the original installation whenever the system runs updates.
  12. Click 
    Next
    .
  13. Click 
    Install
    .
  14. In the 
    Completing the BlastSystemSetup Setup Wizard
     screen, select 
    Launch BlastSystemSetup Configuration
    .
  15. Click 
    Finish
    . By default, the Blast System utility automatically launches the Blast System Configuration interface after the installation is finished.
The 
CiscoBlastSystemSetup.exe
 extracts the installers needed to set up the Windows roles and features and installs the Blast System modules. However, these installers do not run until you provide the necessary data in the 
CiscoBlastSystemSetup
 configuration interface.